IBIS Model i218LM
Hi, I'm looking for the Ibis model for the i218LM. Could you provide me the link to where this ibis model resides? Thanks,--Lisa
View Article802.3az (EEE) support on X550-T1/2 NICs
According to the Intel X550 datasheet (1), the controller supports IEEE 802.3az Energy Efficient Ethernet (EEE). It's also added as a key feature on the Intel's X550 Product Brief (2). However, it...
View ArticleIntel I210: Synchronized Output Clock on SDP Pins
Hi, I am not sure if this is the right place to post this question, if not please correct me. I am using an Intel I210 card on my linux PC. I was trying to generate a clock output on one of the SDP...
View ArticleI210 Windows Driver Source code
Hi, We're developping software that runs under Windows Embbeded Standard and hardware using Intel I210 controler.We require low-level access driver to be able to control TX timestamps or IPG in order...
View ArticleVLAN creation on Windows 10 Enterprise TP
Hello, there. This morning I upgraded my fully functionnal Windows 8.1 Enterprise installation to Windows 10 Technical Preview. Before that, I downloaded the Intel Network Adapter Driver from this...
View ArticleI210 driver issue in Linux
Hi, I am using Ubuntu 16.04 LTS operating system, with igb-5.3.5.4 driver. I have two I210 Ics on board.I have programmed iNVM in both devices and"lspci" is identifying the devices and lsmod also...
View ArticleIntel X550-T2 Card not compatible to HP 1950-24G-2SFP+-2XGT-PoE+ Switch
Hi,i have the following issue. i am using a workstation equipped with Intel X550-T2 card and connected both 10Gbase-T ports with a cat7 cable to switch-port 27/28. switch-port 27/28 are also 10Gbase-T...
View ArticleHow to enable JTAG port on i210?
Hi, We are struggling to get the JTAG chain working on WGI210. Do we need to set some pins at a particular level before we can activate this? Is there a defined startup sequence needed for this?...
View ArticleHow to set multi vlan id use SR-IOV
I have use SR-IOV in my proxmox, and I was passthrough 2 virtual Function NIC card to my vm-pfsense[code]root@pve:~# lspci |grep Eth|grep I35007:00.0 Ethernet controller: Intel Corporation I350 Gigabit...
View ArticleIntel X710 (X710DA4) link Down
Hi! Neededhelp! I have the adapter X710DA4 and X710DA2, and using LR SFP Modules Intel DUAL RATE 1G/10G SFP+ LR (bailed) FTLX1471D3BCV-IT.There is a problem for inclusion in Juniper switch, link is...
View ArticleOS getting rebooted automatically post Driver install
I have downloaded Intel NIC driver for “Intel(R) Gigabit 4PI350-t rNDC“ NIC adapter for Windows 10 OS from below link...
View ArticleIntel 82577LM Gigabit Network Controller failure
I have integrated Intel 82577LM Gigabit Network Controller installed in my Dell Latitude E6510.After installing updated driver from Intel and running hardware test it stopped working (displays "This...
View ArticleIntel X540-T2 Windows 10
Is there any possibility to get an 540-T2 running on Windows 10 1607?After Driverinstallation i got an Code 10, Driver could not be startet Error. Thanks for any Help.
View ArticleClik here to view.
Intel I210-T1 driver issue
Hi, i am an IT student at a german university. Currently i am working on my bachelor´s thesis about the PTP protocol. For this reason i got a Intel network adapter I210-T1, which has support for the...
View ArticleCan't link down an X710 4x10G interface with linux "ifconfig eth down"
- other party says link up no matter what - any clue ?ThanksLior
View ArticleClik here to view.
I350: Device ID 1521 is sometimes 151F / lanconfw64e: c86a2017 - "IOCTL to...
Dear Intel Community, in our industrial measurement device, we have designed an embedded Ethernet card with 3 chips I350 (NH1350AM2) dual 1G Ethernet interfaces.We have at last 6 I350 chips in each...
View ArticleClik here to view.
Ethernet CTLR Single Chip keep sending reset signal
Hi i am using Ethernet CTLR Single Chip at my productand there is some failure at my product come from this chipi have debug the unit and found that it keep sending reset signal to processor chipright...
View Articlewhat is PEX mean
Hi I am involving in using ethernet controlleri am reading the data sheet and found one signal name PEXcan anybody tell me what is the meaning of this signal
View ArticleEthernet driver ubuntu 14.04 - Ethnernet controller I219-LM
Hello i am trying to enable ethernet in Dell Precision supporting Ubuntu 14.04. When i downloaded the drivers from the download siteand try "make" the make has support for only cleaning files and no...
View Articleinterfacing I210IS to Broadcom 5461S PHY in SGMII mode
I have an I210IS device, interfacing to Broadcom BCM5461S in SGMII mode.Currently I don't have MDIO from I210 connected to PHY, I loaded "Dev_Start_I210_Sgmii_NOMNG_16Mb_A2_3.25_0.03.bin" driver into...
View Article