Clik here to view.
Does the X540-T2 NIC supported on Windows Server 2016?
Does the X540-T2 NIC supported on Windows Server 2016?
View ArticleFlashing Intel X540-T2 with firmware
Hi, I recently bought a (second hand) Intel X540-T2 network adapter for my DIY-NAS (my workstation already has one). Unfortunately, it seems to have problems booting on my ASUS Maximus 6 Gene board...
View ArticleCannot install driver for i340-T4 on Windows 10
I'm trying to install the Proset driver and utilities but the installation says it cannot find any Intel adapters. Windows 10 found the adapter just fine and installed the Windows Update version of the...
View ArticleI219-LM UDP Transport Issue
We have procured over a dozen NUC6i7KYK (mfg 07/2017) to act as a receiver of a moderate rate (~320Mbps) UDP stream of data. We have found that the I219-LM adapter is dropping packets. We have been...
View ArticleX710 NICs on Hyper-V 2016, can't set performance to Virtualization
We have two Hyper-V 2016 servers in core mode, both have a pair of Intel X710 Adapters. Both have Hyper-V role enabled and the latest Intel firmware, drivers and Windows patches. Using the PowerShell...
View ArticleClik here to view.
X710 strips incoming vlan tag with SRIOV
Hi, I have a VM using SRIOV interfaces based on X710 interfaces. This VM is connected to a physical router through the VF.I would like to enable vlan tagging on the VM. I can ping the physical router...
View ArticleClik here to view.
i40e x710 4x10G card not working anymore with DAC
Using an updated driver, I cannot seem to get my interfaces up. Looks like the driver is not allowing the NIC to work due to the SFP+ module type, which worked previously on my Debian Stretch host....
View ArticleX550-T2 Yottamark valid, but MAC wrong?
Like others, I bought an X550-T2 (direct from Amazon themselves) and the Yottamark is valid, but the MAC doesn’t match. Is this going to be an on-going production problem?
View ArticleFreeBSD ixl0: Malicious Driver Detection event / Flapping / Update firmware...
Hello; I have a Box (supermicro) with: S.O : FreeBSD 11.1-STABLE (FreeNAS) NIC: - Intel Corporation Ethernet Controller X710 for 10GbE SFP+ (rev 02).- Intel(R) Ethernet Connection XL710/X722...
View ArticleIntel 82574L Blank Chip, How to write MAC Address, firmware in Windows 10
Please tell me the correct way to write a new hardware MAC address and load firmware into a blank Intel 82574L Gigabit Ethernet Controller Chip under Windows 10 Embedded. Windows would be running on a...
View Articlenetwerk verbinding verbreekt steeds
I have a Intel(R) 82579LM Gigabit Network Connection adapterI run Windows 10My network keeps disconnecting while in hibernate mode, and while working as wellI installed PROWinx64.exeI disabled the...
View ArticleFreeBSD ixl0: Malicious Driver Detection event
I have the same issue with FreeNAS 11.1-U1. I created a bug report for FreeNAS and they are looking into it, but they were a little perplexed that a newer driver for FreeBSD was available but wasn't...
View ArticleClik here to view.
duplicate MAC address of two different X520-DA2 NICs
Hello, my question is directed to Intel NIC developers - we (CDN77) are using your X520-DA2 cards in thousands of servers - we have discovered that two different X520-DA2 NICs we have in our network do...
View ArticleClik here to view.
i210 windows driver source
Hi, We are working on a i210 flash-less design in which the i210 operates in Serdes/1000Base-BX mode attached to an external optical module. We have already validated the design as it has passed all...
View ArticleIs it possible to connect XL710-QDA2 directly using XLDACBL3 - without...
Hi All, I am using two DELL Poweredge R430 servers and each server has one dual port XL710-QDA2 [1]. Now we want to connect these two NICs directly using XLDACBL3 [2] cable, but we are not sure if the...
View ArticleClik here to view.
Flashing Intel X540-T2 with firmware
Hi, I recently bought a (second hand) Intel X540-T2 network adapter for my DIY-NAS (my workstation already has one). Unfortunately, it seems to have problems booting on my ASUS Maximus 6 Gene board...
View Articlei40e driver does not work due to the unsupported SFP+ module type
I compiled and installed the network adapter driver for PCIe 40 Gb Ethernet(version 3.4.2). The driver is also loaded in the kernel successfully (Ubuntu 16.04). However, when I connect QSFP+ cables I...
View ArticleIntel Ethernet Connection I218-LM "this device cannot start. (Code 10)"
I have got that problem on few laptops Dell Precision 3150. I have tried different versions of drivers, bios and clean Windows installation and problem still persist.
View Articlei40e x710 4x10G card not working anymore with DAC
Using an updated driver, I cannot seem to get my interfaces up. Looks like the driver is not allowing the NIC to work due to the SFP+ module type, which worked previously on my Debian Stretch host....
View ArticleX710 NICs on Hyper-V 2016, can't set performance to Virtualization
We have two Hyper-V 2016 servers in core mode, both have a pair of Intel X710 Adapters. Both have Hyper-V role enabled and the latest Intel firmware, drivers and Windows patches. Using the PowerShell...
View Article