Clik here to view.
X710 - eeprom check failed - Tx/Rx traffic disabled
Hello, I am using following Ethernet controller on one of our systems, and once in a while I run into following error after bootup, resulting in the port not sending/receiving packets....
View ArticleUnable to establish link with Intel 82599ES 10-Gigabit SFI/SFP+ Network...
Hi, I'm looking for help establishing (and troubleshooting) a link to a SPAN in promiscuous mode on Ubuntu Server 14.04. This link was up and running and seeing packets for a few weeks. To help with an...
View ArticleSNMP for Intel ET Gigabit Dual Port server addapter issue with ANS
Hello. I started a new thread, because the old thread (SNMP issue with ANS ) don't have any answer from Intel's team since 2013 year.I have installed the last version of PROWinx32.exe (21.1) with...
View ArticleI210 Configuration PCIe Only
My platform is a Q7 module which already implements an I210 on PCIe. I am designing a carrier board which includes 2 additional I210s on the Q7 PCIe bus. The Q7 module is currently being tested on a...
View ArticleI210 MAC Address Factory Setting
Does the I210 ship with a unique MAC Address for each chip, or do MACs need to be purchased and manually assigned? In my experience it's always been the latter, but the manual has some bits that...
View ArticleI210 driver issue in Linux
Hi, I am using Ubuntu 16.04 LTS operating system, with igb-5.3.5.4 driver. I have two I210 Ics on board.I have programmed iNVM in both devices and"lspci" is identifying the devices and lsmod also...
View ArticleEthernet CTLR Single Chip keep sending reset signal
Hi i am using Ethernet CTLR Single Chip at my productand there is some failure at my product come from this chipi have debug the unit and found that it keep sending reset signal to processor chipright...
View ArticleClik here to view.
Dell T7600 does not boot with a X540-T2
Hi,I just upgraded a Dell T7600 Workstation. I also wanted to add a 10Gbit ethernet card, but the computer does not boost correct. The BIOS is starting with loading but it hangs before the OS is...
View Articleinterfacing I210IS to Broadcom 5461S PHY in SGMII mode
I have an I210IS device, interfacing to Broadcom BCM5461S in SGMII mode.Currently I don't have MDIO from I210 connected to PHY, I loaded "Dev_Start_I210_Sgmii_NOMNG_16Mb_A2_3.25_0.03.bin" driver into...
View ArticleEthernet driver ubuntu 14.04 - Ethnernet controller I219-LM
Hello i am trying to enable ethernet in Dell Precision supporting Ubuntu 14.04. When i downloaded the drivers from the download siteand try "make" the make has support for only cleaning files and no...
View ArticleIntel X540-T2 Windows 10
Is there any possibility to get an 540-T2 running on Windows 10 1607?After Driverinstallation i got an Code 10, Driver could not be startet Error. Thanks for any Help.
View ArticleClik here to view.
Two NICs, two different names
I have two NICs that are suppose to be the same part number, however, one is recognized as a dual port server adapter, while the other is recognized as a dual port network connector. Can anyone tell me...
View ArticleI210 Configuration PCIe Only
My platform is a Q7 module which already implements an I210 on PCIe. I am designing a carrier board which includes 2 additional I210s on the Q7 PCIe bus. The Q7 module is currently being tested on a...
View ArticleXeon-D 1541 SR-IOV VF in Promiscuous mode
Hi, I am using a Xeon-D 1541, with (2) x552/x557 10G Ethernet cards. I am able to enable VFs and have the latest Linux Kernel/iproute2 (both v4.8.0). I am attempting to put a VF into "Promiscuous Mode"...
View ArticleClik here to view.
OS getting rebooted automatically post Driver install
I have downloaded Intel NIC driver for “Intel(R) Gigabit 4PI350-t rNDC“ NIC adapter for Windows 10 OS from below link...
View ArticleClik here to view.
TX driver issue detected, PF reset issued. and drop packages. Intel x710
Hello I have 10 host Dell R730xd with Ethernet Converged Network Adapter X710-DA4 and we have installed VMware 6.0u2 hosts and vSAN. The cards at first seem to work well and preform well however we now...
View ArticleClik here to view.
Jumpers for remote LED?
My server chassis has two LEDs for LAN connectivity and/or activity. The motherboard does not have any such jumper, and I wanted to know if Intel had *any* NIC cards with a jumper for LAN activity...
View ArticleI210: Device ID 1533 is sometimes 1531
Dear Intel Community In our device we have two WGI210IT ethernet controllers and we are facing an issue with them: Very rarley, let's say less than once per 100 boot ups, we see that the device ID is...
View ArticleCorrect jumper for J3 on XL710 (Newbie)
Hello,In this thread the XL710 J3 jumper is mentioned:Re: STAG support on XL710? I found two types of jumpers: closed:...
View Article82576 Gigabit Ethernet: Enabling MPE bit causes Unknown Unicast to accept
Hi, We are using 82576 Gigabit Ethernet Controller, as per the document (8.10.1 Receive Control Register - RCTL (0x00100; R/W), page No. 515) attached and also the ethtool output, - Even if the UPE...
View Article